sequential shifter for r154

after looking at lloyd smiths drift 1uz twin turbo s13 here is Australia that is of it tits i was wondering how much a shifter like his setup would be worth
and how hard are they to get a hold off

link to vid kid is one sick driver
https://www.youtube.com/watch?v=9mu394LdJVQ

ps i know ikeya used to make one but pfft if i can find anything about it on the web
the was also another company that made one that only did 1st to 4th changes and the rest was h pattern think it was stillway or something

I have been importing them for 14+ years now, and I have never seen one for a Toyota trans, new or used.
But I did adapt one meant for an S13 to a W58.
Just takes an adaptor, with the mounting surface at the correct height above the W58 shifter mounting surface,
and a special bushing in the shifter arm ro accept the Nissan lower bushing.

This will NOT work on an R154, due to the reverse shifter travel being longer.
But I suspect that an S14 Ikeya will work for it, as the S14 trans also has a longer reverse throw.

The only way to tell, is to have an R154, and an S14 Ikeya sitting in the same room, and start measuring.
That was what I had to do with the W58/S13 conversion.

yeah knew you had one for the w58 looks boss so they make them for the nissan boxs tho correct so anyone tried to fit a 350z six speed into a cressy yet?

I'm in the middle of putting a CD001 into my X7, now.

Gordon Duax,

May I ask, how the sequential doing after all this while u hv been using? Are u using it?